2006 corolla where is starter

Recently I have been having issues when I start my Corolla. I turn the key it seems to turn over once or twice then it seems like it slips and does not start. It so far will start on the s I have a Toyota Corolla with some weird behavior. Kind of a splash sizzle. I have a Toyota Corolla CE, i noticed that there is something strange from my dashboard, when you start your engine, the lights on your dashboard will turn on automatically, but mine turn on a Having starter issues. Got it replaced a week ago because it wouldnt engage but would make sounds that its spinning.

Push starting wouldnt work aswell so hsd it replaced. Again after 1 week of dri Review another car. Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus.

Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies. Report Follow. Best Answer Mark helpful.

Mark helpful. Your Answer:. The process for replacing the starter is really straightforward. I would give this job 3 out of 5 wrenches on the difficulty scale…. The following steps walk you through the process of replacing the starter on a Toyota Corolla. These instructions would also apply for a Corolla, Matrix or Pontiac Vibe. The starter on a Toyota Corolla is found right above the oil filter.

As is seen in this photo. The starter with solenoid attached is near the center of the image. Then disconnect the electrical connections on the solenoid. One is a plastic connector where you need to press down the tab on the side with your thumb or a flat-head screwdriver, and pull it out.

Then remove the two 14mm bolts holding the starter on, one on the top, and one on the bottom. Remove the old starter. Position of the new starter in the same place as the old starter. Re-insert the bolts in the reverse order. Do yourself a favor, save a couple hundred bucks and do the repair yourself. Denso remanufactured starter. Corolla Starter TYC. Check out this post for tips on figuring out if the problem is your battery, starter, or alternator. Search for: Search. Date: October 7, Author: Richard Tomlinsen.

I would give this job 3 out of 5 wrenches on the difficulty scale… Tools and parts needed for this repair: car jack and jackstands Socket Wrench with 10mm and 14mm Sockets , or Wrench — 10mm and 12mm Flat-head Screwdriver replacement starter Corolla Step by Step Procedure for Replacing the Starter in a Toyota Corolla These are the steps that will be covered in this picture guide: Remove the negative battery terminal.

Jack up the vehicle and secure it with jack-stands. Disconnect the plastic electrical connector from the existing starter. Remove the grounding cable using a 12mm wrench. Remove the two 14mm bolts holding on the old starter and remove it. Position the new starter and re-install the two 14mm bolts. Reconnect the grounding cable using a 12mm wrench. Reconnect the electrical connector.

Reconnect the negative battery terminal.